Replacement for Delta RP4993 Seats and Springs, 24 Pack
24 rubber seats and 24 stainless springs for Delta and Peerless faucets built on the seat-and-spring design. Two of each per faucet, so one pack rebuilds up to 12 faucets.
Replaces these part numbers
| OEM part numbers | Aftermarket equivalents |
|---|---|
| Delta RP4993 Delta NRP4993 Delta RP4993B | Danco 88103 86968 DL-9 |
Will it fit?
Fits
- Delta single-handle ball valve kitchen and lavatory faucets
- Delta 1700, 1900 and 600 series and the Delta 2650
- Select Delta two-handle stem faucets that use seats and springs
- Peerless faucets on the same ball valve design
Not compatible with
- Delta DST Diamond Seal faucets
- Delta Touch2O models
- Delta 35955LF
- Faucets with a single ceramic disc cartridge and nothing underneath it
Is this your part?
Pull the handle and bonnet and lift the ball assembly out. Two small rubber seats sitting on springs down in the valve body means this is your part. If the valve holds a single ceramic disc cartridge with nothing underneath it, it is a different design and this pack will not help.
When to replace it
The spout drips with the handle closed, water weeps past the ball when the faucet is off, or the faucet keeps running no matter how far the handle turns. Worn rubber seats and tired springs are the usual cause.
Specifications
| FourHome part | 4H838511-1 |
|---|---|
| UPC | 850054895165 |
| Seat | 7/16 in. (11.1 mm) outside diameter, 1/4 in. (6.35 mm) tall |
| Spring | 3/8 in. (9.5 mm) base, 5/16 in. (7.9 mm) tall |
| Materials | Rubber seats, stainless steel springs |
| Pack | 24 seats and 24 springs, 48 pieces |
What is in the box
- 24 rubber seats
- 24 stainless steel springs
- Resealable package
How to install it
Time: 10 to 15 minutes per faucet. Tools: Allen key, Adjustable pliers, Pencil or small Allen key to lift the old seats.
- Shut the supply stops and open the faucet to bleed pressure.
- Pop the handle cap, back out the handle screw and lift the handle.
- Unscrew the bonnet and lift out the cam and ball.
- Scoop the old seats and springs out of the valve body with an Allen key or a pencil tip.
- Drop each new spring in wide end down and rest the seat on the narrow end. A spring in upside down is the one mistake that leaves it dripping.
- Reassemble in reverse and test.
Questions
How many faucets does one pack rebuild?
Up to 12. Each faucet takes two seats and two springs.
Should I replace the ball too?
If the ball is pitted, scored or ridged, new seats will not fully seal against it. Change it in the same visit.
Does it fit a Delta Touch2O or Diamond Seal faucet?
No. DST Diamond Seal faucets, Touch2O models and the 35955LF use a different design.
Is this the same repair as Danco 88103?
Yes. It serves the same repair on the same valve.
Related parts
Repair guides
FourHome is not affiliated with or endorsed by any faucet manufacturer. Brand names and part numbers are used only to identify compatibility.