Pop-Up Sink Drain Stopper Replacement, 5 Pack, 1-3/8 in.
Five 5 in. pop-up stoppers with a 1-3/8 in. stainless steel cap for bathroom, kitchen and utility sinks worked by a pivot rod.
Replaces these part numbers
| OEM part numbers | Aftermarket equivalents |
|---|---|
| Universal lift-rod pop-up stopper (5 in. long, 1-3/8 in. cap) | Danco 80418 |
Will it fit?
Fits
- Bathroom and lavatory sinks with a lift rod behind the faucet
- Kitchen, wash basin and utility sinks with a pivot-rod pop-up
- Standard 1-1/4 in. pop-up drain bodies
Not compatible with
- Push-button or click-clack stoppers
- Lift-and-turn stoppers
- Basket-strainer kitchen sink drains
- Tub and shower drains
Is this your part?
Look under the sink. The right drain has a lift rod behind the faucet and a pivot rod entering the back of the drain body. Your old stopper pulls straight up once the pivot rod nut is loosened and has a slotted strap on its shaft. The cap measures about 1-3/8 in. across.
When to replace it
The basin will not hold water, drains too slowly, the stopper sits crooked or sticks halfway open, or the rim has cracked or corroded. The drain body is usually fine: the stopper is the part that wears out.
Specifications
| FourHome part | 4H815A520 |
|---|---|
| UPC | 850054895820 |
| Overall length | 5 in. |
| Cap diameter | 1-3/8 in. |
| Materials | Stainless steel cap, molded white plastic body |
| Strap | 3 holes for pivot rod height |
| Pieces | 5 stoppers |
What is in the box
- 5 pop-up stoppers
- Pivot rod, ball and lift rod not included: the linkage already under your sink is reused
How to install it
Time: About 5 minutes per sink. Tools: Hands, Pliers (sometimes).
- Loosen the pivot rod nut on the back of the drain body under the sink.
- Pull the pivot rod back and lift the old stopper out.
- Drop the new stopper in with the strap facing the pivot rod.
- Thread the rod through the strap hole that lets the stopper seal flush.
- Tighten the nut by hand plus a quarter turn. Over-tightening crushes the ball seal and starts a drip.
- Pull the lift rod and fill the basin to check the seal.
Questions
Will it fit my sink?
It fits standard pop-up drains worked by a pivot rod. Measure your old stopper: this one is 5 in. long with a 1-3/8 in. cap.
Do I need new linkage?
No. Each stopper reuses the pivot rod, ball and lift rod already under your sink.
Why three holes in the strap?
They set the stopper height so it seals flush whether your linkage sits high or low.
Does it fit push-button drains?
No. It is for pivot-rod pop-ups only, not push-button, click-clack or lift-and-turn stoppers.
Related parts
FourHome is not affiliated with or endorsed by any faucet manufacturer. Brand names and part numbers are used only to identify compatibility.